KUAT TEKAN BETON MUTU TINGGI DENGAN PENAMBAHAN CONPLAST SP 337
DOI:
https://doi.org/10.36982/jtg.v3i1.14Abstract
Concrete is one of the building materials are very useful in the construction, where concrete is a mixture ofPortland cement (PC) or other hydraulic cement composition includes a mixture determined between fine
aggregate, coarse aggregate and water, with or without the use of additional materials. The study was conducted
to determine the compressive strength of concrete and other specifications that concrete is achieved by the
addition of Conplast SP 337. That is done using a cube-shaped test specimens measuring 15 cm x 15 cm x 15 cm
with 5 (five) variation of mixture B1, B2, B3, B4, and B5, each four (4) specimens. for each test age of 3 days, the
age of 7 days, 14 days, 21 days and 28 days. From the research, it was found that the compressive strength of
concrete with each stir the mixture obtained 1.2: 2: 3 (B5) compressive strength greater of 4.5% of the
compressive strength of normal concrete specimen (B1). And the compressive strength of the mortar 1: 2,5: 3 with
the addition of SP 337 (B5) is lower than the compressive strength of normal concrete specimen (B1) amounted to
23.71%.
References
Asri Rusman, Ir., MT. (2011). “PengaruhRongga Buatan Terhadap Kuat Tekan Benda Uji Prismatikâ€, Jurna Bearing, Jurusan Sipil Fakultas Teknik Universitas Muhammadiyah Pelambang.
ACI 304-73. Recommended Practice forMeasuring Mixing. American Concrete Institute Committee 304. ACI Manual of Concrete Practice Part I, 1974.
Duff Abrams, 1920;220 Dalam buku Mulyono Tri, IR., MT. 2003. “Teknologi Beton†Penerbit ANDI. Yogyakarta.
Fosroc , “Concreta Admixtureâ€
Mulyono Tri, IR., MT. 2003. “Teknologi Beton†Penerbit ANDI. Yogyakarta.
Moayed N. Al-khalaf, Hana A. Yousif (1986). International Journal of Cement Composites and Lightweight Concrete, Volume 8, Issue 1, February 1986, Pages 45 -50
Nugraha Paul, Antoni . (2007). â€Teknologi Beton†Penerbit Kerjasa LPPM Universitas Kristen Petra dan Penerbit ANDI Surabaya
SNI 1973:2008. “Cara Uji Berat isi, Volume Produksi Campuran dan kadar Udara Betonâ€. Badan Standar Nasional. Jakarta.
SNI 03-2847-2002. “Tata Cara Perhitungan Struktur Beton Untuk Bangunan Gedung†Penerbit Badan Standar Nasional Jakarta.
SNI 03-2834-2000. Tata Cara Pembuatan Rencana Campuran Beton Normal. Departemen Pekerjaan Umum RI, Jakarta.
SNI M-02-1990-F Standar Metode Pengujian KeausanAgregat dengan Mesin Abrasi Los Angelos, Penerbit Departemen Pekerjaan Umum RI. Jakarta.
SNI 03-1968-1990. Metode Pengujian
Analisis Agregat Kasar dan Agregat Halus, Departemen Pekerjaan Umum RI, Jakarta.